How to confirm whether the state of the high-speed punch press is normal?

Before using the high speed punching machine, the staff should first confirm whether the state of the machine tool is normal. Only under the premise of normal conditions can the high-speed punching machine be guaranteed to work normally. So, how to confirm whether the state of the high speed punching machine is normal?

Please confirm the following aspects before operation:

1. Loading capacity

The working pressure of the high-speed punch press needs to be lower than the rated pressure. If the pressure is too high, a hydraulic overload protection device needs to be installed to prevent the punch from damaging the device. Therefore, before operation, it is necessary to calculate the punching bearing capacity of the machine. In between punching operations, keep less than 70% capacity to prolong mechanical life.

2. Stamping capacity

The punching stroke of the high-speed punching machine is related to the stroke curve of the compressor, that is, it cannot reach any position of the slider. In general, you can check the plant's instructions for how much you can reach before the death point. According to the position of the stamping stroke, the "curve" tonnage stamping work capacity needs to be smaller than the normal parameters, otherwise it will cause damage to the clutch.

3. Ability

During energy expenditure, each phase was measured based on the energy released by the weekly flywheel and the energy balance of exercise. If the operating capacity is exceeded for a long time, the motor power is prone to jump. In order to prevent accidents, it is necessary to work under rated conditions to meet operational requirements.