Causes and solutions of high speed punch stuck

1. The die is stuck: first turn off the power supply, there is a hand-climbing hole on the big wheel on the right (or left) side of the high speed punch, directly use the hand-climbing rod, slowly rock it up bit by bit, and then put the The mold can be disassembled and repaired.

If you can't climb up, you can also loosen the three screws in front of the high speed punch, such as loosening between the die punch and the tilting punch, the punch falls off, and then perform hand-climbing, directly climbing the rod wheel, Shake it up little by little to overhaul the mold.

2. The high speed punch is stuck: Generally, the stroke adjustment of the high-speed punch is too large, which will cause damage to the high-speed punch and needs to be repaired by a machine repair professional.

If you encounter this problem when using a high speed punch, do not overhaul the equipment at will, otherwise it may cause more damage to the equipment, and you should find professional maintenance personnel to deal with the problem.