How to prevent freezing of high speed punch?

In order to better maintain the high efficiency of the application of machinery and equipment, the antifreeze measures of high speed precision punching machines are also very critical. Let's follow the manufacturers of precision high speed punching machines to take a look!

     1. The area where the high-speed punch is placed does not need to be large and cannot exceed 10% of the calculated value.

     2. The water output in the fan coil unit does not have to be very small. If the situation deteriorates, it is recommended that the total flow should not be less than 0115m/s.

     3. When using variable flow monitoring, check and measure the outdoor 0°C condition.

     4. When the hot substance of the flushing needle is steam, the installation site of the steam trap should be 300mm away from the Duyu flushing needle, and the intelligent return water should flow back into the water storage tank from the flushing needle.

     5. The fluidity of the hot material of the high-speed punch should be parallel to the fluidity of the gas, but the current fluidity of the hot material and the gas fluidity of the home punch are mostly reversed. This is naturally good for the heat exchanger, but bad for antifreeze, especially when the hot substance is water, which is much easier to lock at lower temperatures.