How to adjust to make the high speed punch work best

The high speed punch should pay attention to the maintenance during the normal application process, which is very important for the adjustment and adjustment of the key points. This ensures that the precision and stability will be achieved when the high speed punching machine is working. See below for detailed maintenance key points.
1. Measure the gap between the slide rail and the guideway and check the friction surface, and adjust and check when necessary.
2. Check the water pump flywheel rolling bearing, etc. such as manual smooth vegetable grease and pipes, connectors, etc.
3. Test and check the balance cylinder posture and the fuel pipe and connector of the automobile oil cleaning system software.
4. Test and check the characteristic impedance of the insulation layer of the motor control circuit and the actual operation control circuit of the household appliance.
5. Test the accuracy of the entire equipment (straightness, flatness, carding gap, etc.), and adjust and review if necessary.
6. Cleaning of the appearance and accessories of the high-speed punch, self-cleaning and mechanical equipment feet (foundation) with the same screw, screw cap clamping and level inspection when necessary.
7. Cleaning, maintenance and inspection of the pump of the smooth oil supply system, pipeline valves, etc.
8. Pneumatic components, pipes, etc. of the gas system are cleaned and maintained, and the posture test is checked.
9. Use 3000-4000 hours to maintain the test of the function of the optical safety device and the test adjustment of the projection angle and the region. The appearance of the spare parts of the circuit system, the contact point is worn. It is necessary to check and adjust the maintenance of loose connection, etc., as well as the test and adjustment of the second-degree drop-rotating cam switch box and the direction changing function. Fuel pipe cleaning, pit cleaning, product oil replacement and working pressure posture and function test adjustment for overload protection equipment. Check and adjust the wear and supporting force of the V-type drive belt of the main motor. The components of the brake release mechanism are disassembled and differentiated (the water pump flywheel is not), cleaned and maintained, and the gap is checked and adjusted. Balance device, component disassembly and differentiation, cleaning inspection and reassembly adjustment.

10. Use 6000-8000 hours of maintenance to disassemble and disassemble the saw tooth crankshaft, clean and maintain, check the tooth occlusion and wear of the saw tooth and the external thread of the crankshaft, and polish and polish the tooth occlusal surface and modify the smooth grease. The total process of the guide rail and slider (ball seat, pressing cover, overload hydraulic cylinder, worm gear, worm, etc.) is dismantled and differentiated, cleaned and maintained, the clearance adjustment pad and the wear surface, the skeleton seal inspection and the modification of the smooth vegetable grease from scratch. The mold pad is disassembled, differentiated and cleaned. Check the worn surfaces and modify the glossy grease from scratch, and then assemble and test run.